Table of Contents
Advertisement
9. Technical Information
10. RV-M7 Diagnostic Provisions
10.1.
Status and Statistics Command
RV-M7 diagnostic information is read using AT commands, while the unit is in the
Command Mode. Refer to the section "User Serial Port Commands" to learn how
to put the RV-M7 modem into the Command Mode.
AT
Command
General Communication Statistics – This command will cause the
ST
RV-M7 to output a table of various operational statistics.
GPS Statistics – Statistics related to the GPS operation, if installed.
ST1
Low-level internal statistics – Returns various low-level statistics.
ST2
These are subject to change in various firmware revisions.
Compile date and time – Returns the data and the time that the
ST3
firmware was compiled.
Run Time – Returns the amount of time that the modem has been
ST4
powered up and running.
ST9
Reset all statistics counters
Statistic Read – Returns numeric values, comma separated, of all
ST10
statistics as described in the ST command.
M7 PL Technical Manual
Command Description
35
Response
Statistics
overview screen
GPS Statistics
overview screen
Low-level
statistics screen
Date and time
Run time display
screen
OK
Run time display
screen
Raveon Technologies Corp.
Advertisement
Table of Contents
