Table of Contents
Advertisement
$GPTLL Message parameters. This command sets
flags that tell the ATLAS PL which internal parameters
to append to the target "Name" when it outputs the TLL
TLLPARM
message. Bit 0 = temperature, Bit 1= velocity, Bit
2=RSSI, Bit 3 = voltage. Enter the number in decimal:
10 sets bits 3 and 1, 8 sets bit 3, 9 sets bits 3 and 0
5.7.
Factory –PL Default Settings
For the UHF ATLAS PL model RV-M7-UC-PL, the factory defaults GPS settings
are:
Radio channel 1 ........................................................464.500 MHz
GPS Mode ...................................................................8
Serial port output message: .........................................none
Over-the-air baud rate:.................................................4800 baud, 2-level
Serial port.....................................................................RS-232, 38400baud,
Hardware flow control ..................................................Off
RF Power Output .........................................................100% (Full power)
Channel number selected ............................................1
Position/Status report interval ......................................10 seconds
Minimum movement distance to report ........................0 (reports even when idle)
Transmission trigger inputs ..........................................0 (digital inputs disabled)
Security KEY (KEYPHRASE).......................................RAVEON
Proximity Alert ..............................................................0, off.
I/O Change reporting....................................................0, off
ID Prefix .......................................................................V
Slot Quantity ................................................................1
Mandown .....................................................................15 seconds
Company Confidential
24
0-15
N/8/1
Raveon Technologies Corp.
0
Advertisement
Table of Contents
