Table of Contents
Advertisement
Unit is OFF
Unit is OFF
Unit is ON
Unit is ON
Alert LED
This LED turns yellow when a normal Alert condition is being transmitted. It
fast-blinks (twice-per-second) when a Critical Alert is being transmitted. It changes to slow-
green blink twice-per-second when the alert has been acknowledged over-the-air. Press
and hold the Alert button for 5 seconds to clear the alert which will turn the Alert LED off.
4.3.
DC Power
DC power for the PL is connected to the 6-pin I/O jack on the bottom-side of the unit. Use
the supplied cable to connect the DC power. The red wire is positive (+) and the black
wire is negative (-).
4.4.
Serial I/O Connector
The 6-pin I/O connector has the following pin-out:
Number
1
3
2
4
5
6
4.5. I/O Connector Type
The I/O connector is a Hirose HR30 series. Circular waterproof. Used for RS232
connection and for the DC input for the charger.
Company Confidential
Raveon Technologies
Charger
Battery
plugged in
Charged
Not lit
No
Steady green
YES
Green blink-
No
2 sec rate
Green blink-
YES
2 sec rate
Function
DSR
TXD
RXD
Switched B+
Ground
Charger Input
13
Battery below
Battery
30%
below 10%
Not lit
Not lit
Steady orange
Steady
orange
Orange blink -
Orange blink-
2 sec rate
0.5 sec rate
Green blink- 2
Steady
sec rate
orange
Notes
Data into the PL. Also used as digital input IN2 for
exception reporting. GND or floating for a 0, >3V
for digital 1. If enabled for digital inputs, the serial
data entering this pin is ignored (except in the
command mode). Use the TRIGBITS command to
set which bits are used as inputs.
Serial data out of the PL.
5-8.5V output, 200mA max current
draw.
System ground
10-15VDC input for charging battery.
BioRapids 100608
Over/Under
temperature
Not lit
Not lit
Steady red
Steady red
Advertisement
Table of Contents
