Oven Ignitor; Gas Regulator; Griddle Plate Assembly; Griddle Ignitor - Jenn-Air PRG3010 series Service

Disassembly Procedures
!

Oven Ignitor

1. Remove oven door, see "Oven Door" procedure.
2. Remove screws securing kick plate at each top
corner.
3. Remove all oven racks and oven rack supports, by
lifting upward and pulling the bottom inward towards
the center of the oven cavity, then downward to
disengage from lower support brackets.
4. Remove screws securing lower support bracket to
oven cavity.
5. Remove oven bottom, by lifting upward and pulling
forward to removing from oven cavity.
6. Disconnect and label wire terminals from oven ignitor.
7. Remove screws securing ignitor and shield to the
burner.
8. Remove ignitor from oven cavity.
9. Reverse procedure to reassemble.

Gas Regulator

1. Disconnect power supply to unit.
2. Remove screws securing kick plate at each top
corner.
3. Shut off gas supply to range, located in the front of the
oven.
4. Remove bracket at gas line elbow, located at the
bottom left of unit using 5/16" socket.
5. Disconnect gas line from left side of the regulator,
using a 7/8" wrench on the compression nut and a
13/16" wrench on the regulator.
6. Remove the regulator from the shut off valve by
securing the shut off valve with a 1" wrench and
unscrew the regulator.
NOTE: When reinstalling regulator make sure to use
pipe sealer on all threaded connections.
NOTE: Verify that there are no gas leaks, by using
soapy water solution.

Griddle Plate Assembly

1. Remove flue cover located at the rear of the griddle.
2. Remove front trim cover.
3. Remove center shipping screw located at the rear of
the griddle (if applicable).
4. Remove screws securing the front of the griddle.
5. Lift griddle assembly straight upward to gain access to
thermostat capillary tube.
6. Slide the thermostat capillary tube out of the griddle
plate channel and place to the side.
7. Remove griddle assembly from the unit.
8. Reverse procedure to reassemble.
22
WARNING
16022882 Rev. 0
To avoid risk of electrical shock, personal injury or death;
disconnect power to unit before servicing.

Griddle Ignitor

1. Remove griddle assembly from unit, see "Griddle Plate
Assembly" procedure.
2. Remove screw securing griddle burner, located at the
rear.
3. Remove burner and place to the side.
4. Disconnect wire terminals from ignitor.
5. Remove screws securing ignitor and shield to griddle
assembly.
6. Remove ignitor from griddle assembly.
7. Reverse procedure to reassemble.

Griddle Thermal Valve

1. Remove control panel, see "Control Panel" procedure.
2. Remove griddle assembly from unit, see "Griddle Plate
Assembly" procedure.
3. Remove screw securing griddle burner, located at the
rear.
4. Remove burner and place to the side.
NOTE: Orifice can be removed for easier replacement of
valve.
5. Disconnect gas line from manifold elbow to griddle
thermal valve.
6. Remove screws securing griddle thermal valve bracket.
7. Remove valve from unit.
8. Reverse procedure to reassemble.

Griddle Thermostat

1. Remove control panel, see "Control Panel" procedure.
2. Remove griddle assembly from unit, see "Griddle Plate
Assembly" procedure steps 1 through 6.
3. Disconnect wire terminals from thermostat.
4. Remove screws securing thermostat to control panel.
5. Gently remove sensing bulb through the hole in the
front baffle.
6. Reverse procedures to reassemble.
©2004 Maytag Services