Remote Code; Lamp Reset - JVC DLA-­X95R Instructions Manual

Remote Code
For changing the remote control code.
You need to configure the remote control according to the settings of this unit.
On the remote control unit, press the [MENU] and [BACK] buttons at the same time for three seconds or longer to
switch the code.
The backlight of the remote control blinks 3 times: change the remote control code to "A"
The backlight of the remote control blinks 2 times: change the remote control code to "B"
Setting
A
B
Lamp Reset
For resetting the lamp time to "0".
"Resetting the Lamp Time" p. 67
Glossary of Network Terminology
DHCP
IP Address
Subnet Mask
Default Gateway
MAC Address
Change the remote control code from "B" to "A".
Change the remote control code from "A" to "B".
: Abbreviation for Dynamic Host Configuration Protocol. This is a protocol for the network
to assign an IP address automatically to the connected device.
: Numeric characters for identifying the device that is connected to the network.
: Numeric characters that define the bit count used for the network address that is a
segment of the IP address.
: Server for communicating beyond the network that is divided by the subnet mask.
: Abbreviation for Media Access Control address. This is a number that is unique to each
network adapter. Each of the network adapters is assigned with a unique MAC address.
Description
63