Safety Switch-Off - Miele KM 5947 Operating And Installation Instructions

Safety switch-off

Your cooktop is equipped with a safety
switch-off.
For too-long operating time
If one of the cooking zones is heated
for an unusually long period of time
(see Table), and the power settings are
not altered, the cooktop will switch itself
off automatically and the corresponding
residual heat indication will appear.
To use the cooking zone again, switch
it back on in the usual way.
Power setting*
h
1 / 1.
2 / 2.
3 / 3.
4 / 4.
5 / 5.
6 / 6.
7 / 7.
8 / 8.
9
* The power levels marked with a dot
are available only with the extended
power levels (see "Programming").
Maximum
operating time in
hours
2
10
5
5
4
3
2
2
2
1
If the sensors are covered
Your cooktop will switch off
automatically if one or more of the
sensors remains covered for longer
than approximately 10 seconds, for
example by finger contact, food boiling
over, or by any object laid on top of
them.
At the same time an acoustic signal
sounds every 30 seconds (for a
maximum of 10 minutes), while in the
display of the covered sensor switch an
F will flash:
^ Clean the control area or remove the
obstruction.
This will shut off the acoustic signal and
the F goes out.
^ Switch the cooktop back on again
using the ON/OFF sensor s. You can
then resume operation as usual.
Safety features
31