Printer Self-Test - Intermec PB40 Quick Start Manual

Printer Self-Test

Push the red button and hold for about four seconds to print a
self-test. Below is an explanation of the print-out.
Self-Test Print-out Explanation
Test Item Description
F/W Ver The internal software version (4.26 for printer, 1.09
or greater for card reader)
Timeout The seconds between printing and sleep mode.
Baud Rate The speed at which the printer receives data.
Parity Odd, Even, or None
Data Bits Matches with computer sending data to printer.
Handshake The way the printer handles flow control from host.
Burn Adj Amount of heat used to print on the thermal paper.
Beeper May be turned On or Off.
Batt Volt Current voltage of the battery pack.
Batt Temp Temperature of the battery.
Flash/RAM 1 Mb or 4 Mb Flash/1 Mb or 4 Mb RAM
Boot Version Boot sector firmware.
Prnhd Temp Temperature of print head (between 0 and 50 de-
grees).
Infrared Not available at this time.
Device Name Type of device (i.e. 4t for 4 inch thermal printer)
Device Nickname Shows user name for printer.
Available Fonts "LOC" shows whether a font is Resident (R) or
Downloaded (D). "CPI" shows characters per inch.
"DESCRIPTION" describes the font. "NAMES"
give the "Easy Print" name, the Line Printer name,
and the hexadecimal equivalent of that name.
Available Graphics "LOC" shows whether a font is Resident (R) or
Downloaded (D). "CPI" shows characters per inch.
"DESCRIPTION" describes the graphic.
"NAMES" give the "Easy Print" name, the Line
Printer name, and the hexadecimal equivalent of that
name.
8 PB40 Printer Quick Start Guide