Remote Control Rc - Kathrein UFS 702si Operator's Manual

Remote control

Remote control RC 660

The RC 660 remote control supports up to four devices
(which are supplied with the RC 660 as standard) as well
as the receivers of the UFD 5xx (not UFD 552, 554, 558)
and UFD 4xx families.
First switch all receivers off at the power switch.
To confi gure a receiver to an infrared code:
Switch on the relevant receiver.
On the remote control simultaneously press
Address 1 = +
Then switch the receiver off again at the power switch and
do the same for the other units (
receiver; + +
for fourth receiver)
Make sure only one receiver is on at a time!
To switch the remote control to an infrared code:
When you have confi gured all receivers to their infrared
code, to switch between units on the remote control do the
following:
For the fi rst receiver's remote (address 1) press
the second receiver
and for the fourth receiver
+ (red) = Kathrein UFD 5xx code for remote control
RC 400
The RC 600 and RC 650 remote controls cannot be
replaced!
+
+
for third receiver and
+
; for the third receiver
+
.
+ for second
+ +
+
; for
+
;
13