Olivetti AR-FN6 Service Manua page 8

7) Attach the power supply unit.
Attach the power supply unit to the hanging portions and secure it
using the supplied three screws.
Hanging portion
Hanging portion
Screws
8) Connect the power supply unit harness to the PCU PWB of the main
unit of the printer.
<1>Remove the screw that fixes the harness cover of the main unit of the
printer and slide the harness cover up to remove it.
Process the harness cover as shown in the illustration.
<2>Connect the power supply unit harness connector to CN11
(red connector) of the PCU PWB of the main unit of the printer.
CN11
<3>Reattach the harness cover to its original position and fix it with the
removed screw.
At this time, ensure that the power supply unit harness is arranged
as shown in the illustration.
Optional power
supply harnesses
Wire saddle
Wire saddle
* Fix the harness securely to the wire saddle.
Y105620-2
Screws
Optional power supply unit
Screw
Harness cover
Connector
Screw
Harness cover
Wire saddle
4-3
9) Remove the AC inlet cover and then remove the rear cabinet of the
stand/paper drawer.
<1>Remove the screw that fixes the AC inlet cover and then remove the
AC inlet cover.
Screw
(* Similar work for the multi purpose drawer)
<2>Remove the AC cord of the power supply unit from the inlet
connector of the main unit of the printer.
Remove the four screws that fix the rear cabinet and then remove the
rear cabinet.
(* Similar work for the multi purpose drawer)
10) Arrange the harness of the finisher.
<1>Pass the harness of the finisher between the power supply unit and
the frame of the stand/paper drawer and connect it to the connector
of the power supply unit.
<2>Fit the snap band attached to the finisher at the position shown in the
illustration to fix the harness.
Snap band
Finisher harness
(* Similar work for the multi purpose drawer)
AC inlet cover
Rear cabinet
Power supply unit
connector
Service Manual