Olivetti AR-FN6 Service Manua page 7

<4>Open the front cover of the finisher and fix the finisher with three
screws A at the positions shown in the illustration.
Then, close the front cover and close the paper tray of the stand/
paper drawer.
Screws A
<5>Attach the mounting plates to the positions shown in the illustration
and fix them with screws A.
Mounting plates
Desk frame
Caution: Insert the mounting plate under the desk frame.
4) Insert the staple cartridge.
<1>Pull out the staple unit.
<2>Remove the sealing tape from the staple cartridge.
Y105620-2
(Front side)
Screws A
4A=H IE@A
Screws A
Mounting plate
<3>Insert the staple cartridge.
<4>Slide the release lever to the left and return the staple unit.
5) Attach the trays.
Attach tray 1, tray 2 to the positions shown in the illustration.
Steps 6) and after are the procedure to be carried out when a multi
purpose drawer has been installed.
If a stand/MPD & 2000 sheet paper drawer or a stand/3 x 500 sheet
paper drawer has been installed, carry out steps 9).
6) Process the AC inlet cover attached to the rear cabinet of the stand/
paper drawer.
<1>Remove the two screws that secure the rear cabinet and remove the
rear cabinet.
<2>Remove the screw that fixes the AC inlet cover and then remove the
AC inlet cover.
Process the AC inlet cover as shown in the illustration.
4-2
6H=O
6H=O
Screw
Rear
cabinet
Screw
Cut out.
Screw
AC inlet cover
AC inlet cover
Service Manual