Warnings - Graco TexSpray GTX Repair Parts Manual

Burn Hazard
Equipment surfaces and fluid that is heated can become very hot during operation. To avoid severe
burns, do not touch hot fluid or equipment. Wait until equipment/fluid has cooled completely.
Pressurized Equipment Hazard
Compressed air can inject in skin. Air tubing rupture can cause injury if disconnect while under
pressure. To reduce risk of injury:
D Never exceed maximum working pressure of any attachment
D Do not direct air stream at body
D Follow Pressure Relief Procedure, page 6 whenever you are instructed to relieve pressure, stop
spraying, service equipment, install or clean spray nozzle or disconnect or connect hose.
Cleaning Solvent with Plastic Parts Hazard
Use only compatible solvents to clean plastic structural or pressure-containing parts. Many solvents
can degrade plastic parts to the point where they could fail. Such failure could cause serious injury or
property damage. See the Technical Data section on page 26 in this instruction manual and in all
other equipment manuals. Read the fluid and solvent manufacturer's warnings.
Personal Protective Equipment
Wear appropriate protective equipment when operating, servicing, or when in the operating area of
this equipment to help protect yourself from serious injury, including eye injury, inhalation of toxic
fumes, burns and hearing loss. This equipment includes, but is not limited to:
D protective eye wear
D clothing and respirator as recommended by fluid and solvent manufacturer
D hearing protection
D gloves
Water or material remaining in unit when temperatures are below freezing can damage pump and/or delay
startup.
To insure water and material are completely drained out of unit:
D Remove material line from sprayer
D Tip sprayer to allow material (water) to flow out of pump inlet.
Before adding material or staring unit in cold weather, run warm water through pump.
WARNING
CAUTION
309916 3