Viking Professional & Designer 450 Series Installation Manual
Built-in dishwashers
Hide thumbs
Also See for Professional & Designer 450 Series:
- Use & care manual (22 pages) ,
- Installation manual (12 pages) ,
- Use & care manual (22 pages)
Table of Contents
Advertisement
Quick Links
Download this manual
See also:
Use and Care Manual
Advertisement
Table of Contents
Related Manuals for Viking Professional & Designer 450 Series
Summary of Contents for Viking Professional & Designer 450 Series
- Page 1 Viking Installation Guide Viking Range Corporation 111 Front Street Greenwood, Mississippi 38930 USA (662) 455-1200 For product information, call 1-888-VIKING1 (845-4641) or visit the Viking Web site at vikingrange.com Professional & Designer 450 Series Built-In Dishwashers F20408B (092308J)
-
Page 2: Table Of Contents
Table of Contents IMPORTANT– Please Read and Follow! • Before beginning–please read these • Please ensure that this product is properly instructions completely and carefully. grounded. Warnings & Important Information ______________________________________ 3 • Do not remove permanently affixed labels, • The installer should leave these instructions Dimensions &... -
Page 3: Dimensions & Cutout Dimensions
Dimensions & Cutout Dimensions Specifications Professional Series 26-3/8” 26-3/8” Built-In Dishwasher (67.0 cm) (67.0 cm) 23-3/4” 23-1/8” Description 450 Model (60.3 cm) (59.0 cm) Overall width 23-7/8” (60.6 cm) Overall height from floor 33-7/8” (86.0 cm) min. 2-5/8” 3-3/16” 35” (89.0 cm) max. (6.7 cm) (8.1 cm) Overall depth from rear–Professional... -
Page 4: Specifications
Custom Door Panel (Specifications) (Installation Option) Have the overlay panel constructed per dimensions. The panel thickness MAY NOT exceed 5/8” (1.6 cm) for flush installation in most cabinets. Ensure that the design, construction, 11-17/32" 5-7/8" and installation of the panel overlay and its (29.3 cm) (14.9 cm) handle mounting is sufficient to reliably operate... -
Page 5: General Information
General Information General Information • Read these instructions carefully and • For service convenience, a shut-off valve NOTE: Be sure to run the drain line through 3. The edges of the opening mentioned in completely before installing the dishwasher. (not supplied) should be installed in the the hole to the sink compartment before Item (2) should, if the partition is wood, The installation should be carried out by a... -
Page 6: Hardwire Conduit Option
Hardwire Conduit Option Trim Installation Options To install dishwasher without trim, remove the 6 screws and washers (3 per side) and remove trim. To attach wiper gasket to dishwasher, pull protective film off adhesive back on wiper gaskets and apply to leading edge of dishwasher frame. -
Page 7: Trim Installation Options
Trim Installation Options (cont’d.) Trim Installation Options (cont’d.) To install dishwasher cabinet flush with trim, remove the 6 screws and washers (3 Dishwasher will ship with trim installed for panel flush install. If needed, attach wiper gasket by pulling protective film off adhesive back on wiper per side) holding side trim on. -
Page 8: Counter Balance Spring Adjustment
Counter Balance Spring Adjustment - If Necessary Installation Procedure Increase tension Decrease tension Disconnect cable from hook. Set counter balance spring connector in appropriate location. Using tie strap attached to dishwasher, band water line, Carefully lay dishwasher on its back and attach the kick plate brackets. - Page 9 Installation Procedure (cont’d.) Installation Procedure (cont’d.) Air Gap Air Gap Minimum 20” (50.8 cm) from floor (Discharge with air gap) (Discharge with food waste disposer and air gap) Attach screws through trim pieces Install High Loop Clip, which is provided, a minimum of into cabinets.
-
Page 10: Performance Checklist
Performance Checklist Testing for Leaks Final Preparation • Some stainless steel parts may have a • Remove packaging and parts. plastic protective wrap which must be peeled off. • Turn on the water supply and check for leaks. Unit Reset •...