Download Print this page
Viking Designer 200 Series Installation Manual
Viking Designer 200 Series Installation Manual

Viking Designer 200 Series Installation Manual

Built-in dishwashers
Hide thumbs Also See for Designer 200 Series:

Advertisement

Viking Installation Guide
Professional & Designer 200/325E/450E Series
Built-In Dishwashers

Advertisement

loading
Need help?

Need help?

Do you have a question about the Designer 200 Series and is the answer not in the manual?

Questions and answers

Summary of Contents for Viking Designer 200 Series

  • Page 1 Viking Installation Guide Professional & Designer 200/325E/450E Series Built-In Dishwashers...
  • Page 2 Please Read and Follow! W A R N I N G Make sure that incoming voltage is the same as unit rating. An electric rating plate specifying voltage, hertz, and amps is attached to the product. Wiring the dishwasher with more voltage than it is rated for may cause severe damage.
  • Page 3 Please Read and Follow! W A R N I N G W A R N I N G W A R N I N G Please Read and Follow! shall be used if required by NFP -70 (National Electric Code), federal/state/local laws, or local ordinances.
  • Page 4: Built-In Dishwasher

    (67.0 cm) 23-3/4” 23-1/8” (60.3 cm) (59.0 cm) 2-1/4” (7.3 cm) (5.7 cm) Cabinet Flush Panel Flush Custom Panel (200/450E Models) 23-3/4” 23-1/8” (60.3 cm) (59.0 cm) Note: A 2” (5.1 cm) cut-out is required for water supply and discharge lines.
  • Page 5 11-17/32" (29.3 cm) 5/8" (1.6 cm) 5/8" (1.6 cm) (1.6 cm) Use 1/4" router bit ø1/8" 4 places (.3 cm) 29" 10" (73.7 cm) (25.4 cm) 10-5/8" (27.0 cm) 22-21/32" (57.5 cm) 23-9/32" (59.1 cm) with trim 23-7/8” (60.6 cm) without trim NOTE: 5/8"...
  • Page 6 NOTE: W A R N I N G Plumbing connections must comply with C A U T I O N applicable sanitary, safety, and plumbing The dishwasher has a factory installed codes. backflow preventer. Do Not add an additional check valve. NOTE: NOTE: NOTE:...
  • Page 7 NOTE: UL approved strain relief NOTE: Green Ground NOTE: Black Green White Ground Common...
  • Page 9 NOTE: Increase tension Decrease tension NOTE: Equal distance Down...
  • Page 10 Front Panel Attached Front Panel Removed Front Panel Attached Front Panel Removed 1.0” (2.5 cm) Minimum 20” (50.8 cm) from floor Cut here for 3/4” Cut here for 5/8” (1.6 cm) (1.9 cm)
  • Page 11 Air Gap Air Gap...