Summary of Contents for Viking Professional 200 Series
Page 1
All manuals and user guides at all-guides.com Viking Installation Guide Viking Range Corporation 111 Front Street Greenwood, Mississippi 38930 USA (662) 455-1200 For product information, call 1-888-VIKING1 (845-4641) or visit the Viking Web site at vikingrange.com Professional & Designer 200/325/450 Series Built-In Dishwashers F20757 EN (072010)
All manuals and user guides at all-guides.com Table of Contents IMPORTANT– Please Read and Follow! • Before beginning–please read these • Please ensure that this product is properly instructions completely and carefully. grounded. • Do not remove permanently affixed labels, •...
Page 3
• The required use of a GFI is normally related to the location of a receptacle with respect to any significant sources of water or moisture. • Viking Range Corporation will NOT warranty any problems resulting from GFI outlets which are not installed properly or do not meet the requirements below.
All manuals and user guides at all-guides.com Custom Door Panel (Installation Option) (Specifications for FDB200/DFB450 Models) Have the overlay panel constructed per dimensions. The panel thickness MAY NOT exceed 5/8” (1.6 cm) for flush installation in most cabinets. Ensure that the design, construction, 11-17/32"...
All manuals and user guides at all-guides.com General Information General Information • Read these instructions carefully and • For service convenience, a shut-off valve Electrical Connections in Item (2) should, if the partition is completely before installing the dishwasher. (not supplied) should be installed in the wood, be smooth and rounded or, if Grounding Instructions The installation should be carried out by a...
All manuals and user guides at all-guides.com Hardwire Conduit Option Trim Installation Options (not available on all units) To install dishwasher without trim, remove the 6 screws and washers (3 per side) and remove trim. To attach wiper gasket to dishwasher, pull protective film off adhesive back on wiper gaskets and apply to leading edge of dishwasher frame.
Page 8
All manuals and user guides at all-guides.com Trim Installation Options (cont’d.) Trim Installation Options (cont’d.) (not available on all units) (not available on all units) Dishwasher will ship with trim installed for panel flush install. If needed, To install dishwasher cabinet flush with trim, remove the 6 screws and washers (3 attach wiper gasket by pulling protective film off adhesive back on wiper per side) holding side trim on.
All manuals and user guides at all-guides.com Counter Balance Spring Adjustment - If Necessary Installation Procedure Increase tension Decrease tension Disconnect cable from hook. Set counter balance spring connector in appropriate location. Carefully lay dishwasher on its back and attach the kick To adjust the depth of the kick plate, loosen screws on plate brackets.
Page 10
All manuals and user guides at all-guides.com Installation Procedure (cont’d.) Installation Procedure (cont’d.) Front Panel Attached Front Panel Removed Attach screws through trim pieces into cabinets. Attach screws through bracket into cabinets (select models). (select models). Remove front panel to access the front leveling legs. 1.0”...
All manuals and user guides at all-guides.com Installation Procedure (cont’d.) Performance Checklist Air Gap Air Gap Testing for Leaks Unit Reset • If the unit should need to be reset for any A qualified installer should carry out the reason, push and hold the “START” button following checks: for 4 seconds.
All servicing should be referred to a qualified technician. Contact Viking Range Corporation, 1-888-VIKING1 (845-4641), for the nearest service parts distributor in your area or write to:...