Performance Checklist; Testing For Leaks; Service & Registration; Final Preparation - Viking Professional & Designer 450 Series Installation Manual

Performance Checklist

Testing for Leaks

Final Preparation

• Some stainless steel parts may have a
• Remove packaging and parts.
• Turn on the water supply and check for
leaks.
Unit Reset
• Turn the power on at breaker/fuse box and
• If the unit should need to be reset for any
test the dishwasher operation by running a
rinse and hold cycle. (This should take
about 12 minutes.)
• Turn off the electrical power and check for
leaks under the dishwasher.
• Make sure that no kinks have developed in
the drain lines.
Service & Registration
Only authorized replacement parts may be used in performing service on the dishwasher. Do not
repair or replace any part of the appliance unless specifically recommended in the manual. All
other servicing should be referred to a qualified authorized technician.
Record the following information. You will need it if service is ever required. The serial number
and model number for your dishwasher are located on the identification plate mounted on the
bottom left side of the dishwasher door opening.
Model number Date installed
_________________________________________ _________________________________________
Serial number Dealer's name
_________________________________________ _________________________________________
Date of purchase Phone number
_________________________________________ _________________________________________
18
plastic protective wrap which must be
peeled off.
reason, push and hold the "START" button
for 4 seconds.
19