Installer Checklist; Final Instructions; Self-Help Hints - Viking 100 Series Installation Manual

Installation
NOTICE
If you have a European kitchen or want to install a wooden kickplate to match your kitchen,
please refer to one of the two drawings given below. Follow the same instructions on the
brackets as for the removable kickplate. Installation should be done following the steps
illustrated in the Figures A, B, C, and D respectively.
See also Page 21.
See also Page 26.
27
NOTICE
The installer is
responsible for the
d i s h w a s h e r
i n s t a l l a t i o n .
I n c o r r e c t
installation is not
covered by the
warranty.
Installer Checklist and Final Instructions
Your installer must have completed and
checked the following:
KThe dishwasher is square and level.
KThe dishwasher is fastened securely to the
cabinetry.
KThe dishwasher door opens and closes
freely. The dishwasher door must close
without hitting any cabinetry or
countertop.
KThe inlet water supply is turned on and
checked for leaks.
KThe drain hose has been connected and
checked for leaks. There must be no kinks
or obstructions in the drain hose.
KThe drain hose must be installed with a
28" (710mm) high drain loop for drain
hook-ups without any air removed.
KIf the dishwasher drain is hooked up to a
garbage disposal, the drain hopper plug
must be removed.
KThe spray arms are free and rotate freely.
KThe rinse cycle has been run.
KThe water level will be below the filter
screen after the end of the wash program.
It is normal to find some water in the drain
filter area.
KSet the water softener to the correct water
hardness for your area. If the dishwasher
drain is connected to a garbage disposal,
make sure that the drain/hopper plug has
been removed.

Final Instructions

• Press the On/Off button to turn the
dishwasher on.
• Power indicator light comes on.
• Use the Program Select button to choose
a washing program.
• Start the program with the
Start/Pause/Cancel button.
• Run the dishwasher through one complete
cycle. When the wash cycle is completed,
use the On/Off button to turn the
dishwasher off.
28

Self-Help Hints

The screen does not come on:
• Check to make sure the breaker to the
dishwasher is in the on position.
• Check to make sure that the supply cord
is plugged.
No water is coming into the dishwasher:
• Check to make sure the hot water shut-off
is in the ON position.
Water does not drain:
• Make sure drain hose is not kinked or
comes out of air gap next to the sink.
• Remove drain hose from disposal making
sure plug is removed.