MOTO GUZZI nevada User Manual page 32

Use+maintenance book
Hide thumbs Also See for nevada:
Table of Contents

Advertisement

Clock
Set the clock as follows:
Enter the "clock" mode by pressing the
TRIP button (1): the parameters listed in
the table will be displayed in sequence.
Keep the TRIP button (1) pressed for more
than 3 seconds to enter hour setting mode.
Hour indication flashes. Press the "TRIP"
button and the hours indication will
increase by 1 hour each second the button
is held down. Three seconds after the
"TRIP" button has been released, the
hours will stop flashing. Set data are
confirmed and setting automatically
switches to seconds. Minutes indication
flashes. Press the "TRIP" button and the
minutes indication will increase by 1 minute
each second the button is held down.
Three seconds after the "TRIP" button has
been released, the minutes will stop
flashing and set data are confirmed.
NOTE
The clock setting mode will only
work when the motorcycle is at standstill
and with the engine stopped.
32
use and maintenance Nevada
External temperature in °C/°F
Indicates the external temperature reading.
When ambient temperature drops below
3°C, the display will switch to the ICE mode
to warn against possible black ice. When
this mode is activated, the display will
automatically switch from the current
function to a flashing air temperature
indication. The ICE mode remains enabled
for 10 seconds and then the display
switches back to the function displayed
earlier. If the external temperature stays
be lo w 3° C, the ICE mo de fl ash i ng
indication is repeated every five minutes
for three times maximum.
If the air temperature sensor is faulty or
disconnected, two flashing horizontal
segments will be displayed.
HAZARD button operation
Pressing the HAZARD button turns on all
four turn indicators (the button will also
flash when activated). The HAZARD
blinker stays on when the key is removed
from the switch, but may not be turned off
by simply pressing the hazard button
again. In order to switch off the hazard
blinker, you must first set the ignition
switch to "
" and then press the HAZARD
button.

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents