Kärcher NT 361 ECO M A Operating Instructions Manual page 13

Operating Instructions
Replace the flat pleat
filter
! Open the filter cover (1) and
remove the flat folded filter (2).
(See imprint on filter element
packaging)
! Dispose of the used filter
element in a dust-tight, sealed
bag in accordance with legal
stipulations.
! Remove any accumulations of
dirt on the clean-air side
! Replace the flat pleat filter
! Close filter cover, it must
audibly engage
NT 361 Eco M A / NT 611 Eco M A
— The vacuuming device is fitted
with a paper filter bag which
has a sliding seal.
NT 361 Eco M A
(manufacture no.: 6.904-210,
5 pieces)
NT 611 Eco M A
(manufacture no.: 6.904-208,
5 pieces)
! If the paper filter bag is full and
the volume flow falls below the
minumum level the bag must
be changed.
At the end of its service life the
device must be disposed of in
accordance with legal
stipulations.
Change the paper filter
bag
! Insert the connecting sleeve (1)
into the suction connector
ensurung that it fits tightly
! Slide in the connecting
sleeve (1) up to the contact
point
! Firmly close the suction
connection with the connecting
sleeve (1) by turning it
clockwise
Note:
A proper fit is ensured by the
"bayonet connection".
English
! Remove the paper filter bag by
pulling it towards the rear (1)
! Pull sliding cover (2) upwards
and tightly seal the paper filter
bag as it is removed. (See
imprint on filter element
packaging)
! Dispose of the used filter
element in a dust-tight, sealed
bag in accordance with legal
stipulations.
22