Corrosion Control Anode; Lubricating The Driveshaft Bearing - TOHATSU MD 35B2 JET Owner's Manual

M25 Jet Drive

Corrosion Control Anode

An anode helps protect the outboard against galvanic corrosion by sacrificing its metal to be
slowly corroded instead of the outboard metals.
An anode is located on the water intake housing. An anode requires periodic inspection, especially
in salt water which will accelerate the erosion. To maintain this corrosion protection, always
replace the anode before it is completely eroded. Never paint or apply a protective coating on the
anode as this will reduce effectiveness of the anode.
a
a - Water intake housing anode

Lubricating the Driveshaft Bearing

Lubricate the driveshaft bearing before each use.
Description
Grease
Grease Gun
IMPORTANT
Where to used
Drive shaft bearing
Drive shaft bearing
: It is important not to use a general all purpose grease for this bearing.
The lubricant recommended is a water resistant grease of the proper
consistency for this application. If a substitute is used, be sure that it is
water resistant and of the same consistency.
Part No.
3HT-72309-0
3HT-65324-0
18 18 18