To Service The Power Board; To Replace The Damper - Electrolux Side by Side Refrigerator Service Manual

Section C - Removal & Installation
To service the power board (Main power supply), open the food and
freezer doors. Remove the kick plate from the bottom of the cabinet.
Looking through the opening at the bottom of the cabinet on the left
side you will see the plastic box containing the power board.
There is one screw in the middle of the front of the white plastic box
holding the control board. Remove the screw and slide the control box
forward. The back of the control box sits on a rail. Now the control box
can be pulled out the front of the product.
This will give you access to the wiring connectors so you can
disconnect the power board and remove the control box out the front
of the refrigerator.
The new power board will come installed in the plastic box. This will
help prevent shipping damage and help with the installation.
Start the control box into the opening and reconnect the wiring using
caution to make sure they are all the way plugged in. Now you can
push the control box back in place and reinstall the screw.
There is a 3 amp fuse mounted on the control board that is used to
protect the board from voltage surges.
To replace the fuse, remove the control board, and lift the fuse out of
the retainer.
To replace the damper, remove the cover by placing a small
screwdriver in the slotted opening in the bottom and push up on the
retaining tab. This will allow you to swing the bottom of the control box
out and lift the top off the retainer.
With the cover removed, you can reach down the right (back) side of
the damper control at the top and feel a release tab. Push out on the
tab and tip the damper out from the top
With the damper tipped out, release the tab in the center of the
electrical connector and unplug the wire harness form the damper.
Insert
screwdriver
in tab
to remove
4 3