Coffee Brewing - Saeco Magic Cappuccino Plus Sin017XNI Operating Instructions Manual

5

COFFEE BREWING

Warning! During coffee brewing, do not remove
Danger of burns.
This should be considered a standard operation.
• Before use, make sure the "hot water/steam" knob
• If the machine is off, switch it on by means of the
power button.
• During the warming phase, the machine ready light
machine is now ready for coffee brewing.
Warning! By pressing the brew button during
the brew unit: Danger of burns.
5.1 Using "illy" Coffee Pods
The machine has been designed and
manufactured to get the best performance
with "illy" pods.
• (Fig.9)
• (Fig.11)
unit from the bottom.
• (Fig.12)
locks into place.
• (Fig.21)
brewed).
the brew button again to stop dispensing water.
• (Fig.14) - Press the "illy" button. The light turns on and
the machine warms up to the right temperature.
• (Fig.10)
make sure the paper of the pod does not stick out of
• Check that the temperature ready light is permanently
on.
• (Fig.11)
the bottom.
• (Fig.12)
locks into place.
• 22 •
• (Fig.13) - Take 1 preheated cup and place it under
the coffee brewing spout.
• (Fig.15) - Press the coffee brew button.
• When the desired quantity of coffee has been reached,
press the coffee brew button again to stop brewing,
and remove the cup of coffee.
• Wait a few seconds after brewing, then remove the
section 9).
(Fig. 8). The
5.2 Using Ground Coffee
For brewing pre-ground coffee, only use the ground
• (Fig.16)
• (Fig.18)
the bottom.
• (Fig.19)
locks into place.
automatically slightly turned towards the left. This
optimal functionality.
• (Fig.21)
brewed).
the brew button again to stop dispensing water.
• (Fig.22)
by turning it from right to left, and drain any water
• (Fig.17) -With the measuring scoop provided, add 1
two coffees, respectively. Clean any coffee residues
• (Fig.18)
the bottom.
• (Fig.19)
locks into place.
• (Fig.20) - Take 1 or 2 preheated cups and place them
placed under the coffee dispensing spouts.
• (Fig.21) - Press the coffee brew button.