Assembly Instructions; Operating Instructions - Kärcher K 2200 IB Operator's Manual

K1800IB/2200IB Washer ManV2.2 9/25/02 6:03 PM Page 4

ASSEMBLY INSTRUCTIONS

Step 1
Slide the handle through the
accessory rack.
3
Step 3
Check oil level. Oil level should
always be between the "FULL" and "ADD"
marks on the dipstick. Be sure the machine is
level when checking the oil level. (Refer to the
engine's operating manual for seasonal
grades.)
Step 5
Fill gas tank with unleaded
gasoline. Do not use leaded gasoline.
Step 2
Align the holes of the accessory
rack to the handle and fasten the four (4) screws.
Step 4
Insert the detergent tray into one
of the slots of your choice and screw in the
fastener. Fill with the proper detergent for
your cleaning project.
Important! Do not run the engine
with a high or low oil level as this can
cause engine damage. If you have fur-
ther questions regarding the engine,
please refer to the engine's operating
manual included with the unit.
You are now ready to
operate your Kärcher
Pressure Washer.

OPERATING INSTRUCTIONS

NOTE: Engines controls shown may appear different.
Step 1
Connect the high pressure hose to the
unit's high pressure outlet.
Step 3 Step 4
Connect Connect garden
garden hose to unit's hose to the cold water
water inlet. source and turn water on
completely.
Step 6 Step 6
Model K 1800 IB:
control to the fast position. Then move the choke
Slide the throttle control to the fast
lever to the "CHOKE" position (only if engine is
position. Then push primer ball three
cool). After starting, move the choke to "RUN".
times. Wait 3 seconds between each
push.
Note: in cold weather push 5 times
Step 7
Pull the starter handle. If
the engine fails to start after 3 pulls
squeeze the trigger gun to release
pressure, and repeat step 7.
Step 2
Insert the Vario spray wand
into the gun. Push in and turn clock-
wise to lock spray wand in place.
4
Step 5
Trigger the gun to
eliminate trapped air, wait for a steady
flow of water to emerge
from the spray nozzle.
Model K 2200 IB: Slide the throttle