Further Steps Single Shot; Further Steps Twin Shot - DT SWISS Forks ER Instruction Manual

3.4.2.3 FURTHER STEPS SINGLE SHOT

• Put the cable around the silver wheel and through the hole.
• Pull on the cable with the hand so that everything gets into its place.
• Tighten the cable with the hand and tighten the M4x4 screw with 1Nm to clamp the cable
• Switch the lever several times through the different positions
• Set the tension of the cable with the setting screw on the pipe so that the lockout is activated when the lever is in position 3.
• Cut the cable to the wished length and apply a cable ferrule at its end.
• Put the cable behind the M2 screw.

3.4.2.4 FURTHER STEPS TWIN SHOT

• Loose the M3x4 screw on the hex wheel
• Put the cable around the hex wheel and under the M3x4 screw
• Pull on the cable with the hand so that everything gets into its place.
• Tighten the cable with the hand and tighten the M3x4 screw with 1Nm to clamp the cable
• Switch the lever several times through the different positions
• Set the tension of the cable with the setting screw on the pipe so that the lockout is activated when the lever is in position 3.
• Cut the cable to the wished length and apply a cable ferrule at its end.
Pos 1
Lockout open
10
Pos 2
Rebound Lockout activated
(only Twin Shot)
Pos 3
Compression Lockout
activated