Advertisement
Chapter 2 Card Installation and Configuration
1. Hardware Installation and Setup
1) Configure the Jumper Settings
Please check jumper setting for details. To install B200P/B400P, user should
follow these steps:
A.
1. The card id of the first card must be set to 0, and the second card
2. The First Card is a card that will be initialized (i.e installing
3. At most of cases, Linux will initialize PCI devices according to
B.
1. If a port will work on NT mode, you should set jumper to CONNECT
2. If a port will work on TE mode, Theoretically it should be to
C.
VoIPon
www.voipon.co.uk
User Manual
Setting Card ID Switch
If user wants to install more than one cards of B200P or B400P in one
pc, you should take care of the card id switch. It has three rules,
which user must follow:
should be set to 1, and so on.
driver) first when system is booting.
PCI slot order. The slot is nearest to the CPU will be initialized
first; the slot at the far end from CPU will be initialized at last.
That is to say, if user has more than one cards of B200P or B400P
in pc, the one is nearest to CPU should be set to card id 0.
Adjusting Termination of S/T Interface (100 ohm)
(ON).
OPEN(OFF), but user might connect to some non-standard isdn
terminal equipments that do not have terminal resistors, for such
equipments, you should set it to CONNECT(ON).
Power Feeding Connector
These jumpers control whether the card will feed power to the external
isdn terminal. User should adjust accordingly.
If the port will work on TE mode, user MUST set the jumper to
OPEN(OFF)
If this port will work on NT mode, the ISDN terminal requires
ISDN power supply, user should set the jumper to CONNECT(ON).
ISDN terminal does not require ISDN power supply, user should
set the jumper to OPEN(OFF).
sales@voipon.co.uk
Tel: +44 (0)1245 808195
Fax: +44 (0)1245 808299
Advertisement
