Changing The Turn Signal Bulb - KTM 2011 990 Supermoto R USA Owner's Manual

ELECTRICAL SYSTEM

Changing the turn signal bulb

13.8
Note
Damage to reflector Reduced luminance.
–
Grease on the lamp will evaporate due to the heat and be deposited on the reflector. Clean the lamp and keep it free of grease before
mounting.
–
Position the headlight mask. Mount and tighten screws
Guideline
Remaining chassis screws
–
Check that the lighting is functioning properly.
101145-10
–
Remove the screw on the rear of the turn signal housing.
–
Carefully remove diffuser
–
Press bulb

it out of the socket.
–
Press the new bulb carefully into the socket and turn it clockwise until it stops.
Turn signal (RY10W/socket BAU15s) (
–
Check the turn signal to make sure it is functioning properly.
–
Position the diffuser.
101147-10
–
Insert the screw and first turn it counterclockwise until it engages in the thread. Tighten
the screw slightly.
.

carefully into the socket, turn it counterclockwise by about 30°, and pull
p. 186)
.

M6 10 Nm (7.4 lbf ft)
127