Lumex Splash Operation Instruction Manual page 3

Only continue if the light on the hand control is
constant or flashing green and if the battery has been
charged within the last 7-10 days.
When the seat reaches the top of the tub:
• Release your finger from the UP button;
• Sit on the side flap and rotate onto the seat;
• E xtend your feet out in front of you and keep your
hands above the seat;
• Press the DOWN button on the hand control;
• Attach the hand control and battery to the edge of
the tub or to a tiled wall.
For convenience during bathing, you may raise or lower
the seat to any desired height by pressing the UP or
DOWN button and releasing it to stop.
When you have finished bathing:
• Retrieve the battery and hand control;
• P ress the UP button until the side flaps are level
with the top of the tub;
• Release the UP button and move onto the side flap;
• Turn while lifting each leg out of the tub;
• Drain the tub.
5. When you are not using the bath lift:
• Disconnect the battery and place on charge;
• Store the lift at the bottom of the tub.
To remove the lift from the tub, place it in its
lowest position and:
• Disconnect the battery from the hand control;
• Place the hand control on the seat;
• Fold in the side flaps;
• W hile holding the top of the backrest, pull the
suction release tags on the rear suction feet then
tilt the bath lift forward (fig 4);
• R elease the tags on the front suction feet and lift
the bath lift out of the tub;
• W rap the hand control cable clockwise around
the seat, positioning the cable coil under the
actuator casing;
• L oop the remainder of the cable around one of
the tubes(fig 5);
• Store the bath lift upright or on its side.
Hand control
Tracks
Battery
Top of
backrest
Suction
release tag
Cable coil Actuator casing
Figure 3
Figure 4
Figure 5
3