Use extreme care when operating a patient lift. This guide covers the use of the LF2020/LF2090 Sit-to-Stand Patient Lift. Keep in mind that the basic safety procedures included in this manual are to be used as a guide only.
Warning: Patient lift may tip over if used incorrectly. Read and adhere to the operating instructions prior to lifting anyone. LF2020/LF2090 Sit-To-Stand Patient Lift Owner’s Manual MAINTENANCE Note: The information contained in this document is based on the latest product information available at the time of publication.
Note: Unless the patient lift is to be used immediately, retain boxes, containers and packing material for use in storing until use of patient lift is required. LF2020/LF2090 Sit-To-Stand Patient Lift Owner’s Manual FEATURES HANDLING PROCEDURES SHIPPING AND TRANSPORTATION INSTRUCTIONS Inspection 1.
8. Attach actuator and pendant to the control box. 9. Tighten all nuts. Warning: Before using Sit-to-Stand Patient Lift, ensure that lift is assembled as described, that all attaching hardware is securely tightened, and that all lift components are secure. LF2020/LF2090 Sit-To-Stand Patient Lift Owner’s Manual...
3. Draw the shoulder straps to the front of the patient close to the chest. LF2020/LF2090 Sit-To-Stand Patient Lift Owner’s Manual OPERATING INSTRUCTIONS 3. After the battery indicator lights go out, push the UP button and the DOWN button on the hand control and ensure that the lift is operating correctly.
Page 10
15. Close the base, and pull the lift away from the bed. 16. Lower the patient to the object intended. 17. Reverse the above procedures when lowering the patient to the bed. LF2020/LF2090 Sit-To-Stand Patient Lift Owner’s Manual...
Page 11
9. Press the “UP” button until the patient’s body is completely left the chair. LF2020/LF2090 Sit-To-Stand Patient Lift Owner’s Manual 10. Transfer to another object can be done at this position without the patient attending a full standing position.
Page 12
2. Do not charge batteries over 12 hours. Green Green FULLY CHARGED NEED CHARGE CHARGE IMMEDIATELY. DON’T USE THE LIFT BAD BATTERIES OR BAD CONNECTION LF2020/LF2090 Sit-To-Stand Patient Lift Owner’s Manual NOTE Charge batteries immediately Charge batteries immediately Charge batteries immediately Replace batteries Exceeded maximum load capacity...
The casters MUST roll and swivel freely. Lightweight waterproof grease LF2020/LF2090 Sit-To-Stand Patient Lift Owner’s Manual CARE AND MAINTENANCE (such as automobile lubricant) should be applied to the ball bearings of the casters every six (6) months.
Ensure that mounting hardware is tight Inspect mounting hardware for wear Ensure that control box is firmly affixed to the mast Ensure that the actuator connecting cable is tight MAINTENANCE SCHEDULE Item LF2020/LF2090 Sit-To-Stand Patient Lift Owner’s Manual Inspect Inspect/ Inspect/ Inspect/adjust initially...
Lift does not work. Battery indicator shows full charge. Notice “click” sound from control box when UP or DOWN button on hand control was pressed. LF2020/LF2090 Sit-To-Stand Patient Lift Owner’s Manual TROUBLESHOOTING Possible Cause Batteries discharged Battery charger defective Batteries defective...
Note: All dimensions given in inches unless otherwise specified. LF2020/LF2090 SIT TO STAND PATIENT LIFT Base width Open: 43" Closed: 26" Base height (Clearance): 6" Overall base length 50" Lifting height range Note: As measured from sling hooks. Minimum: 27"...
(2) a refund of the original purchase price, less depreciation. GF HEALTH PRODUCTS, INC.’S SOLE OBLIGATION AND YOUR EXCLUSIVE REMEDY UNDER THIS WARRANTY SHALL BE LF2020/LF2090 Sit-To-Stand Patient Lift Owner’s Manual LIMITED WARRANTY Inc. warrants LIMITED TO SUCH REPAIR, REPLACEMENT AND/OR REFUND.
Page 18
(province to province). Some states (provinces) do not allow the exclusion or limitation incidental damages, or limitation on how long an implied warranty lasts, so the aforementioned exclusion and limitation may not apply to you. LF2020/LF2090 Sit-To-Stand Patient Lift Owner’s Manual consequential...
Need help?
Do you have a question about the LF2020 and is the answer not in the manual?
Questions and answers