Transport; Malfunctions; Cleaning And Care - ProActiv NJ1 Operating Instructions Manual

Operating instructions NJ1 e-assistant
If the product should be stored or not used
for a long time, the device should be turned on
briefly once a month and driven a few metres
forwards and backwards to prevent the brakes
seizing up. If necessary, before returning to
service, a general function and safety check by
the dealer is recommended.
When the batteries are stored or taken out
of use, these may only be stored with a charge
status of between 70% and 100%, they must
be fully charged at least every two months.
Before re-use, the batteries must be com-
pletely charged.

20 Transport

When transporting in vehicles it must be
noted that the product is not approved for use
as a seat in vehicles or disabled person's vehi-
cles when combined with a manual wheelchair.
All vehicle occupants must only sit on the seats
installed in the vehicle during the journey with
the associated restraint systems. Failing to
observe this leads to increased risk of injury for
the user as well as for third-parties.
To reduce the weight when loading, the
batteries can be removed from the product and
stored separately. The product and all associ-
ated components must be secured during
transport so that they are not damaged (e.g. by
falling over) and do not become a hazard to
persons or other products.
When loading make sure that the cables
and brake lines are not caught up, become
kinked or otherwise damaged. The product
may not be used with damaged cables and / or
brake lines.
The lithium batteries used are classified as
hazardous goods for transport by air. It is not
permitted to claim that there is a right to trans-
port them by air. The decision about the trans-
port is the sole responsibility of the airline and
this should be discussed in advance of the
flight or the booking.

21 Malfunctions

In the event of any malfunctions which cannot
be solved by yourself based on the operating
instructions included on delivery, please con-
tact your dealer or PRO ACTIV.
Malfunctions must be solved before any
further use or, if they occur during the journey,
this must be interrupted immediately.

22 Cleaning and care

Regular cleaning of the product is prescribed
to prevent the components becoming clogged
up due to dirt. In particular, the product should
be carefully cleaned after every major use, e.g.
summer or winter holidays.
For all cleaning processes, only use commer-
cially available, household cleaning agents. Do
not use any abrasive cleaning agents or ag-
gressive, acidic cleaners, to prevent scratching
or fading of the coating or the anodised parts.
Drive and grip units, as well as the batteries,
may only be cleaned by rubbing off with a
damp (not wet) cloth. Always work with just a
little water and keep water away from the elec-
trical contacts.
The drive wheel should be regularly cleared of
contamination. It is recommended that you use
a soft sponge or a soft brush.
After cleaning, check to make sure that the
plug connectors are not damp and, if required,
allow them to dry before re-starting the prod-
uct.
In addition, the plug connectors should be
lubricated with petroleum jelly after cleaning to
protect them against corrosion and moisture.
The product must not be cleaned using
steam or high pressure.
If you need care products for your product,
please contact PRO ACTIV.
18