Lightspeed DELTA PA User Manual page 12

2A. SETTING UP ONE DELTA PA RECEIVER
1. Turn the DELTA PA ON by rotating
the POWER/RCVR 1 knob
clockwise. The GREEN LED will
light.
Channel Selection: Receiver
Each Receiver has 16 user-selectable
channels to choose from. You can
either select a channel manually or
by pressing the SCAN button, which
will automatically select a clear
channel.
2. Clear Channel SCAN
(recommended):
A) Make sure the transmitter(s) is
OFF before pressing this button.
When this button is pressed, the
receiver will cycle through all
16 channels and select a clear
frequency. (This process takes
about 20 seconds.)
B) Once the receiver selects the
clear channel, you will need to
select the same channel on the
corresponding transmitter
(handheld or belt-pack). See
pages
14 and 19 for instructions.
NOTE There are 3 different
groupings of 16 channels available
(620, 640, 660 MHz). Make sure the
receiver module frequency group
is the same frequency group as the
transmitter.
12
RECVR 2
RECVR 2
O/I
POWER/
RECVR 1
POWER
RED: LOW BATT GREEN: ON
CHARGE
RED: CHARGING GREEN: FULL
RECVR 1
Channel 2
RECVR 2
RECVR 2
O/I
POWER/
RECVR 1
POWER
RED: LOW BATT GREEN: ON
CHARGE
RED: CHARGING GREEN: FULL
RECVR 1