Table of Contents
Advertisement
INSTALLING OR REPLACING A RECEIVER
MODULE
NOTE: Make sure the DELTA PA is
turned off.
1. Remove the two screws securing
the module panel using a small
phillips head screwdriver.
2. Remove the module from the
enclosure by carefully inserting
the blade of a small, flat-blade
screwdriver under the face plate
edge and nudging it upward.
3. Grasp the edges of the module
with both hands and slide
it out.
4. Install the new module by
aligning it with the guide rails and
sliding all the way in to engage
the connector at the rear of the
module.
5. Replace the two screws.
10
RECVR 2
RECVR 2
O/I
POWER/
RECVR 1
POWER
RED: LOW BATT
GREEN: ON
Advertisement
Table of Contents
