Park Brake Lever - Polaris 2008 Defense MVRS 800 6X6 Owner's Manual

Park Brake Lever

Engage the park brake when parking
the vehicle to help prevent the vehi-
cle from rolling. Always apply the
service brakes before engaging or
releasing the park brake.
1. Apply the brakes.
2. Pull the park brake lever down-
ward as far as possible.
3. To release the park brake, apply
the brakes. Press the park brake
release inward and move the
lever upward as far as possible.
Operating the vehicle while the park brake is engaged could cause loss of
control and result in serious injury or death. Always disengage the park brake
before operating the vehicle.
When the park brake is fully engaged and the park brake indicator is
illuminated, engine speed is limited to 1300 RPM in all gears, including
neutral. If throttle is applied, this limiting feature prevents operation,
which protects the park brake pads from excessive wear.
Inspect and adjust park brake cable tension after the first 25 hours of
operation and every 100 hours thereafter to ensure proper cable tension.
See page 88.
NOTE:
This feature will not operate properly if the park brake connector or
switch (under the dash) malfunctions or becomes disconnected, or if
the switch has moved. Check for disconnection, then see your Polaris
service technician promptly if this feature fails to operate properly.
FEATURES AND CONTROLS
WARNING
Park Brake
Lever
Park Brake
Release
31