Seat Belts; Seat Removal - Polaris 2008 Defense MVRS 800 6X6 Owner's Manual

FEATURES AND CONTROLS

Seat Belts

This Polaris vehicle is equipped with four-point harness-style seat belts
for the operator and passenger, and for accessory jump seat passengers.
Inspect seat belts for wear, cuts or damage before each use of the vehi-
cle. Replace worn or damaged seat belts promptly. Always make sure
the seat belts are secured for the operator and passengers before riding.
1. Sit in the seat and place the
shoulder belts over your shoul-
ders. Make sure the belts are
not twisted.
2. Slide each shoulder belt link
over the flat end of the lap belt.
3. Slide the flat end of the lap belt
through the latch loop of the
remaining lap belt and press
the hook latch down to secure
it. Make sure the hook loops
through the flat end section.
Riding in this vehicle without wearing the seat belt can result in serious injury
or death in the event of an accident or sudden stop. Always make sure the
seat belts are secured for the operator and passengers before riding.

Seat Removal

To remove the seat, pull up on the front of the seat and slide it toward
the front of the vehicle.
Install the seat by sliding the tabs into the rear of the seat base. Push
down firmly on the front of the seat until the pins are fully seated into
the grommets.
22
WARNING