Charging Cord; Brake Pedal; Park Brake Lever - Polaris 2016 RANGER EV Li-Ion Owner's Manual

FEATURES AND CONTROLS
Auxiliary 12-Volt Terminal Board
The 12-volt terminal board is located under the hood. It contains constant 12-volt, switched
12-volt and ground terminals that can be used to power auxiliary lights and accessories. The
terminals are limited to 10 amps.

Charging Cord

The charging cord is located under the hood on the right side of the vehicle. See page 64 for
charging instructions.

Brake Pedal

Push the brake pedal toward the floor to slow or stop the vehicle. Apply the brakes before
turning the key on.

Park Brake Lever

To help prevent the vehicle from rolling, set the park
brake when parking the vehicle. When the park brake
is set and the park brake indicator is illuminated,
motor speed is limited. If the accelerator is applied,
this limiting feature prevents operation, which
protects the park brake pads from excessive wear.
Tip: This feature will not operate properly if the park brake
connector or switch (under the hood) malfunctions or
becomes disconnected, or if the switch has moved.
Check for disconnection, then see your dealer
promptly if this feature fails to operate properly.
Always apply the service brakes before engaging or
releasing the park brake.
1. Apply the brakes.
2. Pull the park brake lever upward as far as
possible.
To release the park brake, apply the brakes. Press the
park brake release inward and move the lever
downward as far as possible.
32
Set
Park Brake
Release
Release