Winch Operation Switch; Headlight/Taillight Switch - Polaris 2008 Defense MVRS 800 6X6 Owner's Manual

FEATURES AND CONTROLS
Switches

Winch Operation Switch

Use this switch to operate the winch. Winch
operation instructions can be found in the winch
operation guide provided by the winch manufac-
turer.
Install the winch remote to the remote winch
receptacle to operate the winch switch remotely.
The remote is located in the tool pouch.

Headlight/Taillight Switch

The blackout and IR light modes must be
HIGH
deactivated, and the ignition switch must be
in the ON/RUN position to operate the head-
LOW
lights and taillights. The taillights operate
when the light switch is set to either high
beam or low beam.
OFF
NOTE:
If the lights fail to operate, check the
battery switch.
Press the top of the rocker switch toward the dash to place the headlights
on high beam. Move the rocker switch to the center position to place the
headlights on low beam. Press the bottom of the rocker switch to turn
off the headlights and taillights.
AWD/Differential Lock Switch
The AWD/Differential Switch has
three positions:
All Wheel Drive
• All Wheel Drive (AWD)
• Differential Lock (2WD)
Differential Lock
• Differential Unlock
Press the top of the rocker switch to
Differential Unlock
engage All Wheel Drive (AWD). See
page 57 for operating instructions.
Move the rocker switch to the center
position to lock the differential and operate in rear wheel drive. See page
58 for Differential Lock operating instructions.
Press the bottom of the switch to unlock the differential and allow the
two rear drive wheels to operate independently.
29