Write Setup Parameters; Read Setup Parameters; Reading Setup - Viking VX 900 MHz LTR User Manual

PULL DOWN MENUS

4.4.1 WRITE SETUP PARAMETERS

This command sends the contents of a file to the
repeater and programs the EEPROM memory in the
Main Processor Card (MPC).
Program Rptr 1
Ok
Figure 4-14 WRITE SETUP PARAMETERS
Programming Setup Parameters
Count = 1
Figure 4-15 PROGRAM WRITE SETUP
HARDWARE
Figure 4-18 HARDWARE PROGRAMMING FLOWCHART
October 1999
Part No. 001-2009-201
Cancel
HSDB Monitor
RX/TX Data
RF Data
Input Monitor
Revisions
Mode Select
4-6

4.4.2 READ SETUP PARAMETERS

This command reads the contents of the
EEPROM memory of a repeater and loads it into a
buffer. The contents of the buffer is then displayed to
show the programming of the repeater.
Read Setup Parms?
Ok
Figure 4-16 READ SETUP PARAMETERS
Reading Setup Parameters
Attempting access to Repeater
Figure 4-17 READING SETUP
Repeater (1-30)
Home
UID
GoTo
GID
Data Received From Radio
Data Transmitted to Radio
RF Line Monitor
Input Alarm 3/4 Analog Monitor
Normal
Test
Cancel
UID
Home
GID
Pri
Stat
Time