Table of Contents
Advertisement
SOFTWARE
Refer to Section 7 for Alignment Procedures as
shown in the program, alignment points diagrams and
test setup diagrams.
3.5 HELP F1
Help screens are available for most parameters
and options in this program. Whenever a parameter or
options clarification is needed, press F1 and if a help
screen is available it will pop-up on the screen. Press
Escape <ESC> to exit the pop-up screen.
HELP - F1
FILE
EDIT
TRANSFER
HARDWARE
TEST
Figure 3-2 PROGRAMMING FLOWCHART
October 1999
Part No. 001-2009-201
Load
Save
Save As
DOS Shell
Quit ALT X
Setup Parameters F4
Select Repeater
Alarm Configuration
Repeater Type
Delete Repeater
Read Setup Parms F5
Write Setup Parms F6
HSDB Monitor
RX/TX Data
RF Data
TTY Terminal
Revisions
Mode Select
PA
Receiver
Exciter
Full Rptr/Station
RNT Interface
3-4
Advertisement
Table of Contents
