Mitsubishi PKA-RP35GAL Service Manual page 33

OPERATION PROCEDURE
13. REMOVING the SIGNAL RECEIVING P.C. BOARD
(1) Remove the terminal block cover.
(2) Disconnect the connector <yellow> for the wireless remote
controller.
(3) Remove the front panel.(see the photo 1)
(4) Remove the 2screws and signal receiving p.c. board cover.
(5) Remove the signal receiving p.c. board.
PHOTOS & ILLUSTRATION
(Photo 14)
Set screws
Signal receiving p.c. board cover
(Photo 15)
33
Signal receiving p.c. board
Front
panel
Front
panel