Contec CMS-50E User Manual page 10

a short push (click). There are four modes of data display that can be viewed.
Press the power button with a prolonged push (1 second) to enter the Settings Menu Interface (see
Figure 4 ). Please Please Note: Note: When the display direction on the screen is in the Portrait View, you can not
Please Note:
enter the Menu Interface, click the power button to switch to Landscape View.
The user can setup the following parameters in the Settings Menu – Backlight Brightness, Alarm
high-low limits, data transmission, data storage (recording), data upload to computer.
note in the Settings Menu:
CLICK = short press of power button and PRESS CLICK CLICK
a) a) a) Backlight Backlight Backlight adjustment adjustment adjustment
On the main menu interface, click the power button to select "Brightness", Press the power button
and hold to adjust the backlight brightness.
b) b) b) Alarm Alarm setting
Alarm setting setting
On the main menu interface, click the power button to select "Alarm", Press the power button (1sec)
to enter the alarm setting interface as shown in Figure 5:
a. a. a. Adjust Adjust ing the high
Adjusting ing the the high high and
Click the power button to select "Dir", then Press the button to choose Up or Down (this will be the
direction the value of the high-low limits of SpO
To raise the SpO and pulse rate limit, choose "Dir" as 'Up', then Click the power button to highlight
2
the parameter to be adjusted: SpO
Pulse rate high limit (PR ALM HI), Pulse rate low limit (PR ALM LO), Press the power button and
hold to adjust the selected limit to the desired higher value and release the power button once the
higher limit has been reached.
To lower the SpO and pulse rate limit, choose "Dir" as 'Down', then Click the power button to
2
choose the parameter to be adjusted. Press the power button and hold to adjust the selected limit to the
desired lower value and release the power button once the lower limit has been reached.
If If If the the alarm function function is is is on
the alarm alarm function
data of of of SpO data data SpO SpO or or or pulse pulse pulse rate
2 2 2
Figure 4 Main Menu Interface
and low limits s s of of of alarm limit alarm alarms s s
and low low limit
high limit (SPO
2
on, , , the on the device will
the device device will will provide
rate rate is is is beyond beyond beyond the the limit the limit and limit
PRESS PRESS = prolonged push of power button (1sec)
and pulse rate will be adjusted)
2
ALM HI), SpO
2
provide midium-priority
provide midium-priority midium-priority alarm
and intermittent and intermittent alarm intermittent alarm alarm will
7
low limit (SPO ALM LO),
2 2
alarm signal when
alarm signal signal when when the
will occur. will occur. occur.
Please
the
the