C&K systems System 238 User Manual page 33

STANDBY BATTERY TEST
OPTION
INSTALLED
Your alarm system can be programmed to automatically test its standby
battery every 24 hours. During the test, AC power is turned off in order to
monitor the battery under load.
.
To manually test the standby battery, push the
key, enter the digit "6", the digit "4", then push
the # key.
.
The standby battery test takes 2 minutes. During the test, the green AC light will be off.
.
If the battery is okay, the keypad will beep twice.
If the battery is low or dead, the POWER light will flash slowly, the SERVICE light will be
on steady, and the keypad will beep five times.
OPTION
INSTALLED
BELL/SIREN TEST
To test the bells/sirens in your security system:
PIN
Enter your PIN (if required), push the
REQUIRED
enter the digit "6", the digit "3", then push the # key.
.
The bell/siren and keypads will sound for 3 seconds.
*
6
*
6
*
key,
*
4 #
3 #
33