C&K systems System 238 User Manual page 15

.
To bypass more than one zone: enter your
PIN
REQUIRED
PIN (if required), push the
first zone to be bypassed, push the
again, enter the next zone to be bypassed,
and so on. When the last zone to be bypassed
has been entered, push the # key.
.
To indicate that zones have been bypassed, the READY light and the ZONE light will
flash slowly. The red ZONE lights of all bypassed zones will flash to remind you that
bypassed zones are not protected.
.
The procedures for adding a bypass and removing a bypass are identical. To
remove a bypass: enter your PIN, push the
bypass is to be removed, then push the # key.
.
When you have finished bypassing zones, arm the system by entering your PIN and
pushing the # key.
NOTE: Disarming your alarm system
zones).
key, enter the
key
key, enter the zone from which the
REMOVES
ZONE # ZONE #
all bypasses (except 24-hour
#
15