Commissioning; Specifications - Texecom Speech Dialler Installation Manual

Speech Dialler Installation Manual

Commissioning

1. Once all necessary connections have been made to the unit, re-connect the
loudspeaker to the main circuit board and clip the cover on to the base taking
care not to trap any cables.
2. Re-apply mains power to the control panel and reconnect the battery.
3. The dialler will enter its initialisation mode (15 seconds), during which you can:
• Press the red record
then the
-"#$.#)/$&0,,,".
• Press the
4. After the unit has finished initializing/loading defaults the display will show
",,,,1&.$2"#1,,,,". The unit will beep once if it is a Speech Dialler and
twice if it is a Speech & Text Dialler. To select the programming mode enter the
default passcode of
5. The display will show "345)67).898:6;<)!7=6>:6)186>?9@" The unit is
now ready for programming and testing. Please refer to the "Operating
Instructions" for full details.
6. After the dialler has been programmed and tested, secure the front cover with
screw and screw cap that is provided in the spares pack.

Specifications

Supply Voltage:
Current Consumption:
Trigger Inputs:
Outputs:
Telecommunications Approval:
REN Rating:
Dialling Formats:
Dimensions:
Packed Weight:
10
!
"
key. The
#
key to select the language then
$%&'
key 5 times to load the factory default parameters
display will
.
10 - 14VDC
35mA (Standby), 100mA (Active)
4; +ve applied or +ve removed (5 - 24VDC)
2; Open collector switched –ve @100mA
CTR21
1
Pulse or DTMF
140mm x 115mm x 30mm
360g (Approximately)
show: "!"#$%&'()'*+,,,
"
key to accept.
INS232-2