Installing And Removing Ram - @Xi Computer Corporation MTower User Manual

Chapter 5, Upgrading Your Computer

Installing and Removing RAM

NOTE
The type of random access memory (RAM) your computer supports is referred to
as a DIMM (dual in–line memory module). DIMMs are available in many
configurations and specifications. When you decide to add RAM, be sure you
obtain the appropriate DIMMs for your computer's system board. Refer to the
manual that comes with the system board to see whether the system board has
certain rules about installing the DIMMs.
To install a DIMM:
1. Turn off the computer and follow the other recommendations in the section
"Precautions to Follow Before Upgrading" on page
2. Remove the system unit cover (see
on page 43).
3. Hold the DIMM above the socket.
4. Gently press the DIMM vertically into the socket as shown in
Apply equal pressure on each end of the DIMM.
DIMMs are keyed to prevent them from being inserted the wrong way.
5. Make sure the clamps on both sides of the socket have locked the DIMM into
place. The DIMM should be standing straight up.
Use the following procedure to remove a DIMM. Never forcibly remove a DIMM
and never try to remove a DIMM without first releasing it from the socket.
Otherwise, you risk breaking the DIMM and/or the socket. To remove a DIMM:
"Accessing the Interior of Your Computer"
Figure 5-2. Installing DIMMs
Page 48
42.
Figure 5-2.