Advertisement
MAINTENANCE:
The only regular maintenance required is occasional de-scaling.
In common with all water boiler manufacturers, service calls resulting from
limescale are not covered by warranty. Fitting a scale reducer is recommended,
especially in hard water areas.
A service agent should descale the machine regularly. Marco suggest that the
machine be descaled every 3 months if the unit is in a hard water area. In soft
water environments every 6 months should suffice.
CLEANING:
Marco recommend cleaning after each days brewing using a proprietary urn-
cleansing compound. Marco Urn Cleanser (Marco Part number 8000240) is
available in 800g tubs. Instructions are given on each tub.
The exterior of these machines may be cleaned with a damp cloth and a light
detergent. Do not use abrasive cloths or creams, as this will spoil the finish of the
machine. Do not use a water jet or spray. Beware of accidentally operating the
draw off tap when cleaning the front of the machine.
WARNINGS
FLOODING WARNING:
This machine MUST be positioned on a counter with a drainage facility. The machine
can be operated without a basket or urn/receptacle in place which will cause water to
spray/flow directly onto the counter. All potential operators should be fully trained in
its correct use.
SCALDING- Beware of accidentally operating the brewing buttons and the water
drawoff tap (if installed), especially when cleaning the front of the boiler
ALL USERS OF THIS MACHINE SHOULD BE TRAINED AND
SHOULD BE AWARE THAT THE MACHINE DISPENSES VERY HOT
BEVERAGES/WATER.
The utmost care has been taken in the manufacture and testing of this unit. Failure to
install, maintain and or operate this boiler according to the manufacturer's instructions
may result in conditions that can cause injury or damage to property. If in any doubt
about the serviceability of the machine always contact the manufacturer or your supplier
for advice.
Page 4 of 4
1900062
REV.2
Advertisement
