DICE Car Integration Kit for iPod Integration Manual page 26

Operation Overview
BMW business CD radio
5
3
+
1
1 Press the MODE button to access the interface.
Press and hold the Track buttons to RW or FFW. On some
2
older BMW radios the
the same function.
3 Use buttons 1 - 6 to change between modes.
4 Use Random to enable Shuffle Songs.
5 Source indicator
Text display settings
Make sure to select the appropriate text display setting during the initial setup of the DICE kit. You must configure the text option by pressing
DISC 6 then selecting a Track number that corresponds to the designated display:
Track #
99
01
02
03
04
05
06
07
08
09
BMW/Mini Specific Technical Notes
Why do the radio buttons need to be
double-clicked on my early model 3-Series?
Radio/Nav display only shows DISC and Track
number, but there is no iPod control.
Cannot select CD changer source.
Radio/ steering wheel controls do not operate
iPod.
No text display.
No audio from iPod source.
iPod does not charge.
Music is distorted or sound level is too low.
25
AM
SC MODE
Song * Artist *Album
CDC 1
RND TP
4
- -
2 4 6
3 5
m
button must be engaged to perform
Text Displayed On
No Text
Radio
Navigation
Cluster/OBD
MID
Alternate Location
Alt Locat.(large font)
Resume Text
Motorcycle
No Text
Problem
www.diceelectronics.com
BMW radio with Navigation
FM
1
2
m
1
2
3
4
Application
All
3-Series/Z3/Z4/X3/'04-K1200
All with nav.
5-Series/7-Series/X5 w/o nav.
Alternate for 5-Series/7-Series/X5
All with nav.
All with nav.
Use if text does not resume after phone call
05+ K1200
All
Solution
On earlier models of 3-Series and Z3 (1999-2002) vehicles, double-clicking is required
when text is being displayed because the first button press clears the text and the
second button press performs the command.
Select DISC 5 and make sure it is set to Track 01. Here you are making sure that iPod
mode is selected, and not AUX mode (Track 02)
Check DIP switch settings. With the ignition OFF disconnect vehicle harness
from module for a few seconds and reconnect. Verify that the correct button is
used to access the interface (CDC or DSP).
Reset iPod and make sure most recent iPod firmware is installed.
Make sure DIP switch settings are correctly set for text display. Note that early
model Mini Cooper vehicles do not support text. You must also configure the
text as described above
Reset the iPod.
Check all connections. See if iPod charges while connected to computer or wall
charger. You may need to reset the iPod.
Check and make sure all EQ and BASS boost options are turned off on your iPod.
1-888-342-3999
INFO
3
PLAYLIST NAME
CDC 2-01
1 4
* DICE *
2 5
3 6
FM AM
1
MODE
01/02/2008
Press the MODE button to access the interface.
Press this button to change track, press and hold
it to RW or FFW
Use button 1 - 6 to change between modes.
Turn the jog dial to change track. Note that a 9
second timeout is engaged once any of the
alternate display buttons are pressed. If exiting
from any of these sub-screens without waiting for
the normal timeout, you MUST wait for 9 seconds
before being able to use the jog dial again to
navigate content.
Characters
----
12
15
20
11
8
8
----
12
----
TONE SELECT
2
MENU
4