DICE Car Integration Kit for iPod Integration Manual page 25

Connection Diagram
for i-BMW-T kit:
BMW 3, 5, 7 series,
M3, M5 & X5
(left hand side of the trunk)
During installation, make sure that the 3 pin connector from the vehicle does not have a brown wire in the middle. The 3 pin connector of the
phone pre-wiring looks identical to the 3 pin connector of the CD changer pre-wiring! Do not use the 3pin connector that has a brown wire in
the middle, but locate the one that has the brown wire on the side! Incorrect connection will result in permanent damage to the unit and will
not be covered by warranty!
CD Changer cable
(3-pin and 6-pin BMW cables)
for DSP kit:
BMW 5, 7 series, M5 & X5
DSP converter
coax cable
connect to
amplifier
+12V
ground
RCA 6-pin harness
power adapter
Installation Tips / Check List
When routing the vehicle specific harness to the front of the vehicle, some BMW models have a panel
below the glovebox where the DICE module can be stored for easy access.
When installing a DSP kit, you can temporarily attach it to the battery for constant power for testing
purposes, but it should NOT be installed this way.
CD changer connections are normally coiled up and hidden well when a CD changer is not present.
Please make sure to use the CDC connections and not the wiring harness of the phone system—as they
both look the same! Check Connection Diagram above for detailed information.
CD Changer locations:
BMW Z4
2006-2008 M-Coupe & M-Roadster
(between seats, underneath
subwoofer)
BMW Z4
2 1
1
3-pin connector
Make sure the 3-pin connector has a
RED middle wire!
factory CDC harness
Note: CD Changer of BMW Z8 is located right behind the driver's seat.
BMW X3
(underneath carpeting under
the center console)
module
vehicle specific
connector
BMW X3
2
1
2
DSP amplifier
module
vehicle specific
connector
BMW 1999-2002 M-Coupe & M-Roadster
Z3, and Mini Cooper
(right hand side of the trunk)
iPod
MENU
docking
cable
1
2
iPod
MENU
docking
cable
24