Dell OptiPlex 330 User Manual page 88

6. Attach the power and data cables to the floppy drive.
7. Gently slide the floppy drive into place into slot 2.
8. Align the shoulder screws with the screw guides, and slide the drive into the bay until it clicks into place.
1 slot verification number
9. Connect the other end of the data cable to the connector labeled "FLOPPY" on the system board (see
10. Replace the optical drive (see
11. Replace the computer cover (see
NOTICE: To connect a network cable, first plug the cable into the network device and then plug it into the computer.
12. Connect your computer and devices to their electrical outlets, and turn them on.
See the documentation that came with the drive for instructions on installing any software required for drive operation.
13. Enter system setup (see Entering System
14. Verify that your computer works correctly by running the Dell Diagnostics (see
Optical Drive
CAUTION: Before you begin any of the procedures in this section, follow the safety instructions located in the Product Information Guide.
CAUTION: To guard against electrical shock, laceration by moving fan blades, or other unexpected injuries, always unplug your computer from
the electrical outlet before removing the cover.
Removing an Optical Drive
1. Follow the procedures in Before You
NOTICE: Do not pull the drive out of the computer by the drive cables. Doing so may cause damage to cables and the cable connectors.
Optical Drive).
Replacing the Computer Cover).
Setup) and select the appropriate Diskette Drive option.
Begin.
Dell Diagnostics).
System Board Components).