New Sel Sensor Messages; System Board Replacement - Safeguarding Encrypted Data - Dell PowerEdge R900 Series Information Update

New SEL Sensor Messages

The following SEL sensor messages have been added to the systems
management software and remote access card software.
Table 2. Sensor Message Definitions
Sensor Number Message
0x26 PCIE Non Fatal
error
0x27 Generic Fatal
I/O Error
0x28 Processor
Machine Check
Error
NOTE:
For the full name of an abbreviation or acronym used in this table, see "Glossary"
in your Hardware Owner's Manual.
System Board Replacement - Safeguarding
Encrypted Data
On systems using an operating system that supports the Trusted Platform
Module (TPM) and related encryption programs, you can use these features
to secure the contents of the hard drive(s).
If you are using the TPM with an encryption program, you may be prompted
to create a recovery key during system or program setup. Be sure to create and
safely store this recovery key. If you ever need to replace the system board, you
must supply the recovery key when you restart your system or program, before
you can access the encrypted data on your hard drive(s).
Definition
A non-fatal error occurred. The system
will continue to operate normally.
A fatal I/O error occurred. The system
will no longer respond.
A processor error occurred. The system
will no longer respond.
Information Update
7