Before Start-Up - Clarke CR 28 BOOST Operator's Manual

BEFORE START-UP

WARNING!
At every machine start-up, check that, between the deck (4 or 5) and the machine or between the squeegee
(12) and the machine, there is no foreign material which may prevent the deck and the squeegee from lifting.
This check is necessary because, if the machine has been turned off without lifting the BOOST
squeegee, when turned on again, the deck and the squeegee lift automatically.
Brush installation/removal
1. The machine can be equipped with different brushes (88) according to the type of fl oor to be cleaned.
2. For the installation/removal, proceed as follows.
Insert the ignition key (41) and turn it to "I".
WARNING!
Before pressing the switch (34), always check that, between the deck (4) and the machine, there is no foreign
material which may prevent the deck from lifting.
3. Lift the deck by pressing the switch (34).
4. Turn the ignition key (41) to "0" and remove it.
5. Install the brush (88) so that it engages the BOOST
6. To remove the brush, perform steps 2 to 5 in the reverse order.
Brushes and Pads available
Pads
Size Description
14 x 28 Red (5 Pack)
14 x 28 Black (5 Pack)
14 x 28 White (5 Pack)
14 x 28 Blue (5 Pack)
14 x 28 Maroon (10 Pack)
Brushes
Size Description
14 x 28 Poly Brush
14 x 28 Nylon Brush
14 x 28 Grit Brush
Brush application guide
Models
General cleaning:
Concrete
Terrazzo fl oor
Ceramic tiles/quarrystones
Marble
Vinyl tiles
Rubber tiles
Operator's Manual - CR 28 BOOST
deck.
®
Part No.
997001
997000
997002
997006
997018
Part No.
30752A
30751A
30753A
POLYPROPYLENE
®
NYLON CLEAN GRIT
ENGLISH
deck and the
®
13