How To Operate The Machine; How To Start/Stop The Machine; How To Control The Machine; Maintenance - Clarke C2K-16 Operator's Manual

C2k series 230v 50hz polisher
Hide thumbs Also See for C2K-16:
Table of Contents

Advertisement

HOW TO OPERATE THE MACHINE

How To Start/Stop The Machine

WARNING:
Never start a polisher when
the handle is in the vertical
position.
The following step applies to the C2K-1600DS and C2K-
2000DS only:Select high or low speed with the switch
located on the motor cover. Moving the switch lever up
selects high speed. Moving the switch lever down
selects low speed.
The following steps apply to all C2K series:
The switch to start and stop the machine is activated
by the interlock button (1) and the levers (2) under the
handle grips. See figure 5.
To start the machine, follow this procedure:
1. Lower the handle
2. Lock the handle in the best position for operation.
NOTE: Make sure you hold the handle with both
hands.
3. Push the interlock button (1), and apply pressure to
the levers (2). See figure 5.

How To Control The Machine

NOTE: Make sure you hold the handle with both
hands.
The side to side movement of the machine is controlled
by raising the handle and pressing down on the handle.
To move the machine to the left, press down on the
handle slightly. To move the machine to the right, raise
the handle slightly.

MAINTENANCE

WARNING: Maintenance must be done
by authorized personnel
only.
Maintenance Instructions
Return the machine to a Clarke Technology Authorized
Service Location every 12 months for maintenance
inspections.
CLARKE TECHNOLOGY Operator's Manual - C2K Series 230V
1
2
Figure 5
2
Page - 9 -

Advertisement

Table of Contents
loading

Table of Contents