TO PREVENT FIRE OR SHOCK HAZARD, DO NOT USE THIS PLUG WITH AN EXTENSION CORD, RECEPTACLE OR OTHER OUTLET UNLESS THE BLADES CAN BE FULLY INSERTED TO PREVENT BLADE EXPOSURE. TO PREVENT FIRE OR SHOCK HAZARD, DO NOT EXPOSE THIS APPLIANCE TO RAIN OR MOISTURE. The lightning flash with arrow- WARNING: TO REDUCE THE head symbol, within an equi-...
PREPARATION FOR USE UNPACKING AND SET UP • Carefully remove the unit from the carton and remove all packing materials from the unit. • Carefully remove any small strips of tape which may have been used to keep the CD door closed during shipment. •...
SPEAKER CONNECTION Connect each speaker to the corresponding speaker terminals on the back panel of the main unit. Make sure that: • The left speaker is connected to the (L) left pair of speaker terminals, and the right speaker to the (R) right pair of speaker terminals. Also make sure that the speaker wires are correctly connected: •...
POWER SOURCE This system is designed to operate on normal 110/220V 60/50Hz AC house current only. Attempting to operate this system from any other power source may cause damage to the system, and such damage is not covered by your warr- anty.
1.) POWER ON / OFF 2.) POWER ‘ On’ Indicator. 3.) VOLUME Control. 4.) STOP Button. 5.) PROGRAM Button. 6.) MONO / STEREO 7.) Band AM / FM 8.) Function CD / TUNER 9.) Tuning Dial. 10.) PLAY / PAUSE Indicator. 11.) FM STEREO Indicator.
OPERATING INSTRUCTIONS LISTENING TO THE RADIO • Make sure that the FM Lead Wire antenna is extended to its full length. 1.) Press the POWER button to turn the unit “ON comes ‘ On’ . 2.) Press the CD / TUNER button to TUNER 3.) Press the AM / FM 4.) Turn the TUNING control to tune to the desired radio station.
HINTS FOR BETTER RECEPTION The FM lead wire antenna on the back panel should be extended to its full length. You may also have to vary the direction of this antenna until you find the position that provides the best reception. The AM bar antenna is inside the cabinet of the main unit.
PLAYING COMPACT DISCS NOTE: Although this CD player can read CD-R and CD-RW discs, in addition to normal CDs, the playability of CD-R/RW discs may be effected by the type of software that was used to create the discs, as well as the quality and condition of the blank media you are using.
5.) Press the PLAY/PAUSE The PLAY/PAUSE indicator lights up. 6.) Adjust the VOLUME control as desired. 7.) Playback will continue until the end of the disc. When the disc ends the display again shows the total number of tracks on the disc. You may also stop playback at any time by pressing the STOP PAUSE Control To pause momentarily during playback press the PLAY/PAUSE...
REPEAT Playback This feature allows you to continuously repeat a single track or the entire disc. To Repeat A Single Track Press the REPEAT button once. The REPEAT indicator flashes. Press the buttons to select the desired track. Press the PLAY/PAUSE button to begin Repeat Playback of the selected track.
PROGRAMMED Playback This feature allows you to program up to 20 tracks on a disc for playback in any desired order. Note: You cannot program tracks while a disc is playing. If the disc is playing press the STOP button first before beginning the programming steps below: 1.) Press the PROGRAM button to enter the Program Mode.
6.) After the last track has played the player stops and the display shows the total number of tracks on the disc. However the program sequence remains in the memory. Press the PROGRAM button, then the PLAY/PAUSE programmed sequence again. 7.) To cancel the programmed sequence from the memory press the STOP button while in programming mode.
PHONES Jack Connect a set of stereo headphones (not included) with a 3.5mm mini plug to the PHONES jack on front panel, for private listening without disturbing others. Before putting on the headphones reduce the VOLUME control to a low level, then put the headphones on and gradually increase the VOLUME control to a comfortable listening level.
CARE AND MAINTENANCE COMPACT DISC CARE • To remove a disc from its storage case, press down on the center of the case and lift the disc out, holding it carefully by the edges. • Fingerprints and dust should be carefully wiped off the disc’ s recorded surface with a soft cloth.Unlike conventional records, compact discs have no grooves to collect dust and microscopic debris, so gently wiping with a soft cloth should remove most particles.
Need help?
Do you have a question about the JX-CD3150D and is the answer not in the manual?
Questions and answers